2N NetStar Admin manual - Manual (Page 263)

263
11.3 NetStar Installation Guide
Setting IP Address and Time
IP address
Connect to NetStar with HyperTerminal tool
Rate: 115200
Flow control: None
You can also use Putty
Rate: 115200
Serial line: set the COM interface number you are using for connection
between your PC and NetStar
Once you are connected, press <ENTER> to get the login screen. The default login
information is
and . If there is a # character and no login request on the Admin 2n
screen, type and push Enter for confirmation. The login request should get NsCon
displayed.