Incoming parameters (phone is dialling), Outgoing parameters (phone is ringing) – 2N NetStar Admin manual User Manual
Page 46
46
Incoming parameters (phone is dialling)
Call type – determines the preferred type of communication on this port. Choose
one of the
,
,
and
options.
Voice FAX A3.1kHz Audio
56kb Modem
DTMF dial enabled – check this item to make the carrier detect DTMF dialling
from an analogue phone.
Pulse dial enabled – check this item to make the carrier detect pulse dialling
from an analogue phone.
FLASH length [ms] – the parameter sets the maximum time of the FLASH
signal transmitted from a local phone to the PBX. The default value is 150 ms
and the minimum value is 80 ms.
Disable port DTMF detection – use this parameter to disable/enable DTMF
detection using a detector on the board in order to save the internal PBX
detectors.
Outgoing parameters (phone is ringing)
CLI broadcasting mode – the parameter defines the preferred CLIP (Calling
Line Identification Presentation) transmission type. The selections are
,
DTMF
and
.
FSK
none