Step 3: localisation setting – 2N NetStar Admin manual User Manual
Page 20
20
Figure: View of Wizard's Hardware Detection Operations
The boards are detected both in the basic unit and extenders. Once some hardware is
detected, activation takes place, which means that virtual ports are assigned to all the
boards detected (except for VoIP boards). The terminals connected are detected in the
last stage of the wizard hardware configuration. This should make the PBX ready for
further configuration, which is signalled by green board LEDs. The GSM board is the
only board without LED indicators and so its ready status is signalled by the port LEDs.
The current firmware version is loaded into the PBX after the first start–up or every
firmware upgrade and may cause a short delay in the GSM board activation.
Step 3: Localisation setting
Localisation setting is another important step of the
configuration. In this
2N NetStar
®
step you can define the parameters shown in figure below and described in detail in the
chapter. In addition, you can add a language package of your own
including texts and progress tones. Two language packages – Czech and English – are
available in the PBX by default.