2N NetStar Admin manual - Manual (Page 125)

125
6.10 AutoClip Parameters
AutoClip Routing
AutoClip routing is used for routing of incoming calls and SMS messages in NetStar
mainly through the carriers that do not transfer the PBX CLI. For example, an outgoing
call via the GSM carrier identifies itself as a SIM card number assigned to a port, not as
a calling user. For these cases, the information on outgoing calls and messages is
saved into AutoClip routing tables, which help find the originally calling user and route
the incoming call or SMS to this user. For more details on AutoClip routing refer to
Chapter
. 6.10 AutoClip Parameters
AutoClip Parameters
You can save records on outgoing calls/messages including user defined parameters
into the AutoClip table with the aid of AutoClip parameters. To define the AutoClip
parameters, use the
menu. The menu is divided Global Data – AutoClip Parameters
into two parts. A list of available AutoClip parameter sets is on the left. Here add,
remove or rename the sets using the context menu. On the right, you can configure
the parameters of a selected AutoClip parameter set.
Figure: View of AutoClip Parameter Setting Menu Used for Saving
Name – is the name of the AutoClip parameters set.
Number – is the number of the AutoClip parameters set. It has no function in
the current firmware, but is ready for later use.
Store:
Missed – use this option to store only records on unanswered calls
(including rejected) in the AutoClip router.
Answered – use this option to store only records on answered calls
(signalling connections) in the AutoClip router.
Both – use this option to store records on all calls made (answered,
missed, rejected) in the AutoClip router.
Mark record as used:
After alerting – a record is marked as used after the originally calling user
extension starts ringing (Alerting message).
After active – a record is marked as used after the originally calling user