ADS-TEC RAP/RAC1000 User Manual - Manual (Page 101)

IT Infrastructure RAP/RAC1000
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
101
WPA RADIUS SERVER
The Access Point is capable of using an existing Radius server for account authentication.
For this option, the Radius server IP-address must be entered in the IP address box.
The TCP port, on which the Radius server is operated, must be entered under TCP port,
too. Usually, the radius server runs on TCP port 1812.
Using the Radius shared secret, the Access Point will be identified and authenticated at the
radius server.
If two radius servers are used, another configuration may be entered under Secondary, as
an alternative. This specification only comes into effect if the Primary radius server
previously could not be reached. The Access Point will then try to establish a connection to
the Secondary radius server. Confirm this action with Apply settings.