ADS-TEC RAP/RAC1000 User Manual - Manual (Page 129)

IT Infrastructure RAP/RAC1000
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
129
SNMP READ ONLY ACCESS / SNMP READ / WRITE ACCESS :
Note:
Select if you want to configure read-only or read/write access rights according to your
requirements, and fill your data in the corresponding mask.
SNMP Community Name:
The name to be entered here is comparable with a password. Frequently used default
settings are Private or Public.
SNMP Community IP:
Access to the specified Community Name is restricted to the following IP address.
Note:
If you want to allow all source IPs, select the following IP: 0.0.0.0
SNMP Community network mask:
Here you must enter the corresponding network mask for this IP address.
SNMP
V
3
USERNAME AND ENCRYPTION
:
Note:
This function is available only if SNMPv3 was selected. Select if you want to configure
read-only or read/write access rights according to your requirements, and fill your data in
the corresponding mask.
User name:
Assign a user name for authentication with the SNMPv3 protocol.
Password:
Assign a password to your user name.
Note:
The authentication protocol used with this login is MD5.
Preshared Key for encryption:
The preshared key (PSK) is a key that consists of a combination of numbers and letters
and can be used in addition to user name and password. A randomly generated number
code, which may be used as a preshared key, can be created by using the "Generate
PSK" button.