ADS-TEC RAP/RAC1000 User Manual - Manual (Page 96)

IT Infrastructure RAP/RAC1000
96
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
Note:
In client mode, the DFS function is disabled by default. Caused by the radar detection
during data transmission, strong interferences might occur in particular at the client,
which have to be evaluated as Potential Radar Pulses. A very high CPU load and faulty,
frequently occurring radar detection cycles are results of that. For this reason, DFS should
be enabled in client mode only if the client output power exceeds 23dB, and if 30dBm are
required for establishing a stable data connection. If another 5GHz device is located near
the device in question, this might also cause significant disturbances to the client mode, if
DFS is activated there as well.
WLAN1
(A CCESS P OINT & A CCESS C LIENT ) 2.4 GH Z – 802.11 A (FCC):
The FCC setup version for interfaces has the following additional setup options:
Indoor/Outdoor:
Must be enabled if the Access Point is part of a radio connection in the outdoor area.
Certain channels of the 5GHz band may not be used outdoors, and will be excluded by this
option. When used indoors the option indoor can be used. This option is of no importance
for Access Clients.
Point-to-point radio antenna: If you want to connect a point-to-point radio antenna, you
must activate this checkbox.
Note:
DFS and TPC are disabled in this case. The only difference to the A version is, that
version 802.11b/g (FCC) has the point-to-point antenna setup as an additional option.