ADS-TEC RAP/RAC1000 User Manual - Manual (Page 206)

IT Infrastructure RAP/RAC1000
206
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
C ONFIGURATION
Roaming Threshold
To allow a Client to roam to an Access Point already before a connection is lost, the
parameters „SNR-Roaming Threshold“ and „Packet Number below Threshold“ can
be adapted.
The threshold indicates the lower limit from which a connection is considered to be „bad“.
The packet number indicates how many “bad” connections, i.e. below threshold, must be
given to roam the packets.
Example process of configuration
Measuring the signal strengths:
After fixed installation of the Access Points, the current SNR values (Signal Noise Ratio) can
be viewed in the web interface under „Diagnosis  WLAN1 Parameters“. Now the
signal strengths to the Access Points should be measured on the whole area. At least the
points in the direct vicinity of the Access Points and between one or more Access Points
should be recorded.