ADS-TEC RAP/RAC1000 User Manual - Manual (Page 137)

IT Infrastructure RAP/RAC1000
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
137
P ROCEDURE :
1) Save the firmware file in a local folder of your choice on the PC.
2) Start the desired server service or use a freeware program like tftpd32 to make a
firmware update. Further, mind the local device settings on your PC in order to prevent
that communication to your device will be blocked.
3) Now state the path of your folder where the new firmware is located under Browse
and confirm with OK.
Note:
Make sure that the file extension (.bin) of the firmware is indicated, e.g. Ads-tec-RAPxxx-
X.X.X-SVN-R10923M.B-7251.bin
4)
Before you start the update process, it is recommended to take over the factory
defaults of the new firmware.
5) Start the update process via Upload of Firmware Server
During the firmware update, the following dialogue window appears:
Once the LED link on the outbound port shows a constant green light and the ACT LED is
out, the button Retry to Connect can be confirmed.
The device tries to access the web interface. If the update has been successful, the
software update will be displayed
.
Warning:
The power supply must not be interrupted during this process!