ADS-TEC RAP/RAC1000 User Manual - Manual (Page 41)

IT Infrastructure RAP/RAC1000
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
41
WLAN M ODE :
Use this option to select the wireless standard to employ. All clients that are meant to
communicate with this Access Point need to be compatible with the selected wireless
standard.
The following WLAN modes can be chosen:
A
CCESS C LIENT : A CCESS P OINT :
R EGULATORY A UTHORITY
Under this option, select the country in which the device is operated. This country setting
ensures that applicable national regulations are observed in each country.
WLAN1
(A CCESS P OINT & A CCESS C LIENT ) 5 GH Z – 802.11 A (ETSI):
If the WLAN 802.11a mode or in case of the client, the 802.11a/b/g mode is configured,
the following options change:
Hinweis:
The Option „Outdoor“ is just available in Access Point Mode. The Option „Deactivate DFS“
is available in both Modes.
Indoor/Outdoor:
Must be enabled if the Access Point is part of a radio connection in the outdoor area.
Certain channels of the 5GHz band may not be used outdoors, and will be excluded by this
option. When used indoors the option indoor can be used. This option is of no importance
for Access Clients.
Disable DFS:
You may disable DFS if the Access Point is NOT used outdoors. You may also manually set
up channels 36, 40, 44 and 48 as fixed channels, in this case. Additionally, the permissible
maximum output power is reduced. In client mode, in contrast to that, DFS may also be
disabled for outdoor use.