ADS-TEC RAP/RAC1000 User Manual - Manual (Page 122)

IT Infrastructure RAP/RAC1000
122
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
Multi client bridge:
This operating mode allows to use a WLAN client in connection with a non-ads-tec Access
Point. All devices connected with the Ethernet interface of the ads-tec device, are
automatically masked with the MAC address of the WLAN module of the ads-tec device in
the direction of the WLAN. The first device is masked with a layer2-transparent access, and
all further devices are masked with a layer3-transparent access, i.e. only protocol data
might be transmitted.
Single client bridge:
Exactly one Ethernet device, which is masked with a layer2-transparent access, may be
connected behind the client, in this case. The MAC address of this device must be manually
entered.
Note:
If the ads-tec device itself is configured as a DHCP client in the Single bridge mode or in
the Multi client mode, all other connected devices may also use DHCP. The ads-tec device
will automatically initiate DHCP relay in order to forward all corresponding requests.