ADS-TEC RAP/RAC1000 User Manual - Manual (Page 11)

IT Infrastructure RAP/RAC1000
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
11
Note:
The lower 4 channels (non-DFS) can be set to static values if DFS is turned off. Turning
off DFS will however also make the features 60s Scan and Radar Detection unavailable.
• When activating the Access Point, the unit will perform an initial Radar Detection Scan
during which it will wait 60 seconds for a radar impulse on a randomly chosen channel.
Subsequently, it will start operating on this channel.
• If an Access Client detects a radar impulse during operation, the Access Point will be
notified of this via 802.11h. Triggered by this or its own detection of the impulse, the
Access Point will subsequently perform a channel switch to 802.11h. The connection
loss in this case is usually less than 80ms.
• The maximum permissible transmission power is different for each channel. Hence
users are required to correctly set the antenna amplification in case the standard
antenna is replaced!
2.6 A NTENNA L IST FOR USE IN USA AND C ANADA / FCC
• This antenna types can be used with the Access Points and Access Client in USA and
Canada. The antennas can be ordered at ads-tec GmbH. For the correct operation you
have to use an
absorbability cabel for the different antenna types.
Ads-tec part number Ads-tec part description Antenna type Frequency band Gain absorbability
DZ-PCKO-11032-0 RAP Antenne 2,4 GHz SMA-R 5dBi Swivel 2,4 ~ 2,4835 GHz 5 dBi none
DZ-PCKO-11033-0 RAP Antenne 5 GHz SMA-R 7dBi Swivel 5,1 ~ 5,835 GHz 7 dBi none
DZ-PCKO-11034-0 RAP Antenne 2,4 GHz N-fem. 9 dBi Omni 2,4 ~ 2,4835 GHz 9 dBi none
DZ-PCKO-11034-1 RAP Antenne 2,4 GHz N-fem. 12 dBi Omni 2,4 ~ 2,4835 GHz 12 dBi none
DZ-PCKO-11035-0 RAP Antenne 2,4 GHz N-fem. 12 dBi Panel 2,4 ~ 2,4835 GHz 12 dBi none
DZ-PCKO-11035-1 RAP Antenne 2,4 GHz N-fem. 18 dBi Panel 2,4 ~ 2,4835 GHz 18 dBi
minimum 20m
(it is a Ecoflex10* 1 cable to use)
DZ-PCKO-11036-0 RAP Antenne 5 GHz N-fem. 12 dBi Omni 5,1 ~ 5,835 GHz 12 dBi
minimum 14m
(it is a Ecoflex10* 1 cable to use)
DZ-PCKO-11037-0 RAP Antenne 5 GHz N-fem. 12 dBi Panel 5,1 ~ 5,835 GHz 12 dBi
minimum 20m
(it is a Ecoflex10* 1 cable to use)
DZ-PCKO-11037-1 RAP Antenne 5 GHz N-fem. 20 dBi Panel 5,1 ~ 5,835 GHz 20 dBi
minimum 37m
(it is a Ecoflex10* 1 cable to use)
* 1 It has at 2,4GHz 22.5dB/100m absorbability and at 5GHz 35.9dB/100m absorbability. Additional every plug has 0.5dB absorbability.
Warning:
Behalf of the correct operation you have use an absorbability element for the different
antenna types.
Note:
Also light wave conductor cable can be used. It is necessary to use terminating
impedance for the correct use.