ADS-TEC RAP/RAC1000 User Manual - Manual (Page 124)

IT Infrastructure RAP/RAC1000
124
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
N ETWORK -G ROUPS
The Network Groups function allows for grouping IP addresses and IP sub-networks to use
them in the packet filter for filter rules. The status line contains information on the use of
the group. If a group in the packet filter is used once normally the status line „Use in Rule
1“ is output.
Note:
The use of != in Layer2 Filter Wizard for network groups is not supported.