Lenze EMF2179IB - Manual (Page 36)

EMF2179IB communication module (DeviceNet)
Installation
Elements at the front of the communication module
5
5.4
5.4.1

5.4-1 EDSDEN EN 02/2006
5.4 Installation
5.4.1 Elements at the front of the communication module
2179DEN001B
Fig. 5.4-1 EMF2179IB communication module (DeviceNet)
Pos. Description Notes
 Plug connector with double screw connection, 5-pole  5.4-11
 PE shield cable connection
Pos. Description Notes
 DIP switches for setting
z controller address (S1 - S6)
z
baud rate (S7, S8)
z software compatibility with 2175 communication module (S10)
 5.5-2
Pos. Description Notes
 Connection status to the drive controller (two-coloured LED)
 5.5-11  Connection status to the bus (two-coloured LED)
 Drive (green and red drive LED)
Pos. Description Notes
 Fixing screw
 Nameplate
 RKOJN

Note!
Only for 820X and 821X:
If required, use an additional PE shield cable which avoids
EMC-related communication interference in surroundings with
extreme disturbances.
Connections
DIP switch
Displays
Other elements