Rockwell Automation 1761-NET-ENIW MicroLogix Ethernet Interface (ENI) User Manual - Manual (Page 127)

1 Publication 1761-UM006E-EN-P - August 2005
Appendix
A
Specifications
Physical Specifications
Series C and D Ethernet
Specifications Communication Rate: Auto-negotiates 10 Mbps, full- or half-duplex
and 100 Mbps, full- or half-duplex
Connector: 10/100-Base-T
MicroLogix Web Site Visit http://www.ab.com/micrologix for more information on
MicroLogix products. You can find a variety of application information
and White Papers covering specific technical topics.
Description ENI/ENIW Specification
24V dc Power Source Requirement 20.4 to 26.4V dc
24V dc Current Draw 50 mA typical, 100 mA maximum
Maximum Inrush Current 200 mA
Internal Isolation 710V dc for one minute
Vibration operating: 10 to 500 Hz, 5.0g, 0.030 in. peak-to-peak, 2 hour each axis
Shock operating: 30g, ±3 times each axis
non-operating: 35g (DIN Rail Mount) 50g (Panel Mount), ±3 times each axis
Operating Ambient Temperature 0 ° C to +60° C (+32° F to +140° F)
Storage Temperature -40
° C to +85° C (-40° F to +185° F)
Humidity 5% to 95% relative humidity (non-condensing)
Agency Certification
(1)
• UL 1604
• C-UL C22.2 No. 213
• Class I Division 2 Groups A,B,C,D
• CE compliant for all applicable directives
• C-Tick marked for all applicable acts
Radiated and Conducted Emissions: EN 50081-2, Class A
The module has passed testing at the following levels:
• ESD Immunity (EN 61000-4-2) • 4 kV contact, 8 kV air, 4 kV indirect
• Radiated Immunity (EN 61000-4-3) • 10V/m, 80 to 1000 MHz, 80% amplitude modulation, and 900 MHz keyed carrier
• Fast Transient Burst (EN 61000-4-4) • Power supply: 2 kV, 5 kHz
• RS-232 and Ethernet: 1kV, 5 kHz
• Surge Immunity (EN 61000-4-5) • Power Supply: 500V
• Ethernet (unshielded cable): 2 kV
• RS-232 and Ethernet (shielded cable): 1 kV galvanic gun
• Conducted Immunity (EN 61000-4-6) • Power Supply: 10V, 0.15 to 80 MHz
• RS-232 and Ethernet (unshielded cable): 3V, 0.15 to 80 MHz
• RS-232 and Ethernet (shielded cable): 10V, 0.15 to 80 MHz
(1) Shielded Ethernet cable required for marine certification.