Rockwell Automation 1761-NET-ENIW MicroLogix Ethernet Interface (ENI) User Manual - Manual (Page 27)

Publication 1761-UM006E-EN-P - August 2005
Installation and Wiring 2-5
1. Remove the mounting template from
the back of the installation instructions.
2. Secure the template to the mounting
surface.
3. Drill holes through the template.
4. Remove the mounting template.
5. Mount the unit.
ENI/ENIW Port
Identification
Ethernet Connections Ethernet 8-Pin 10/100-Base-T Connector (Port 1)
The Ethernet connector is an RJ45, 10/100-Base-T connector. The
pin-out for the connector is shown below:
Mounting
Template
Write-on area for
Ethernet IP address
RS-232 Mini-DIN (Port 2)
Ethernet Port (Port 1)
Pin Pin Name
1 Tx+
2 Tx-
3 Rx+
4 not used
5 not used
6 Rx-
7 not used
8 not used