Rockwell Automation 1761-NET-ENIW MicroLogix Ethernet Interface (ENI) User Manual - Manual (Page 70)

Publication 1761-UM006E-EN-P - August 2005
5-4 Peer-to-Peer Messaging
Table 5.3 Message Instruction Variables for Sending a Message to a Destination
Controller
Variable Setting
This Controller Parameters:
Communication Command Use any command supported by your controller and the
target device.
Data Table Address Use any valid file.
Size in Elements Use any valid size.
Channel The RS-232 communication channel that is connected to the
ENI/ENIW, typically 0 or 1.
Target Device Parameters:
Message Timeout Leave this value at the default.
Data Table Address Use any valid file.
Local Node Addr (dec). The destination node address, Nodes 0 to 49 (decimal).
Local/Remote Always Local.