Rockwell Automation 1761-NET-ENIW MicroLogix Ethernet Interface (ENI) User Manual - Manual (Page 48)

Publication 1761-UM006E-EN-P - August 2005
4-8 ENI/ENIW Configuration (Nodes 241 to 254)
Use the Configuration Utility Over Ethernet (Series D only)
Redirect the COM port to the ENI/ENIW IP Address
1. Download the Com Port Redirector software from
www.ab.com/micrologix.
2. Install the Com Port Redirector software.
3. Open the Port Redirector configuration utility by selecting
Programs>Com Port Redirector>Configuration.
4. The splash screen appears briefly, followed by the configuration
screen.
5. Click on the Com Setup button.
TIP
When using the ENI/ENIW Configuration Utility via
Ethernet, connect the ENI/ENIW to the same
subnet as the computer.