Rockwell Automation 1761-NET-ENIW MicroLogix Ethernet Interface (ENI) User Manual - Manual (Page 17)

Publication 1761-UM006E-EN-P - August 2005
Product Overview 1-5
Default Settings
The ENI/ENIW has the following default settings:
IMPORTANT
The IP addresses in any of the examples in this
manual were arbitrarily assigned and should only be
used on an isolated Ethernet network. Contact your
system administrator for unique IP addresses if you
are connecting your Ethernet devices to your
employer’s Ethernet network.
Table 1.4 RS-232 Settings
Setting Default Other Options
Baud Rate Autobaud see table 4.2
Handshaking (hardware, software) none none
Data Bits 8 none
Stop Bits 1 none
Parity none none
Table 1.5 DF1 Settings
Setting Default Other Options
Duplicate Message Detection Enabled none
Error Detection Auto-detect (for
Autobaud) Auto-detect when
Autobaud is true,
otherwise CRC
Embedded Response Operation
Disabled
(1)
(1) Connected controllers should be configured for Embedded Responses Disabled or Auto-detect.
none
DLE ACK Timeout 1 second none
DLE NAK Receive 3 NAK retries none
DLE ENQ for Response 3 ENQs retries none
DF1 Node Address Don’t Care