Rockwell Automation 1761-NET-ENIW MicroLogix Ethernet Interface (ENI) User Manual - Manual (Page 35)

Publication 1761-UM006E-EN-P - August 2005
Operation 3-5
2. Select “Ethernet devices” from the available drivers, and then
click “OK” to load the driver into RSLinx.
Once the Ethernet driver is loaded, either highlight and select
“Configure” or simply double click on the Ethernet driver.
3. Click “OK” to accept the default driver name.
TIP
The RSLinx Ethernet/IP driver may also be
used with series B (FRN 2.31) ENIs and higher.
The advantage of this driver is that it can
‘discover’ the ENIs on a network even when
the IP addresses have not been manually
entered. The disadvantage of this driver is that
the RSWho browse displays only the ENI and
not the MicroLogix controller that is attached to
the ENI’s serial port.