Rockwell Automation 1761-NET-ENIW MicroLogix Ethernet Interface (ENI) User Manual - Manual (Page 18)

Publication 1761-UM006E-EN-P - August 2005
1-6 Product Overview
Table 1.6 Ethernet Settings
Setting Default Other Options
Ethernet Speed/Duplex
(1)
(1) Series D only.
10 Mbps half-duplex
(series A, B)
Auto Negotiate (series C, D) 0 = Auto Negotiate
1 = 10 Mbps half-duplex
2 = 10 Mbps full-duplex
3 = 100 Mbps half-duplex
4 = 100 Mbps full-duplex
SMTP Username
(1) null 45 character username
SMTP Password (1) null 45 character password
SMTP Authentication
(1) Disabled 0 = Disabled
1 = Enabled
Configuration Security
Mask 000.000.000.000 Valid IP address
Save/Reset
(2)
(2) See page 4-19.
n/a 0 = save configuration to flash
1 = simple reset
2 = reset to out-of-box defaults
3 = reset to out-of-box, except
maintain current IP
configuration
From String ENI192.168.1.254@eni1761.
org
(4)
(4) TThe ENI/ENIW address, 192.168.1.254 will be replaced by the IP address assigned to the ENI/ENIW. For
example, the string may be [email protected]. If the ENI/ENIW does not have an assigned IP
address, the string will be read as [email protected] for the series D or [email protected]
for series A, B, or C.
ENI/ENIW Identifier
IP Address 000.000.000.000
192.168.1.254
(1)
valid IP Address
Subnet Mask
0.0.0.0
(5)
(5) See page 4-17 for Subnet Mask auto-detect mode details.
valid subnet mask
Gateway Address 0.0.0.0 valid IP address
Security Mask 1 0.0.0.0 valid IP address
Security Mask 2 0.0.0.0 valid IP address
Email Server 000.000.000.000 valid IP address
BOOTP Configuration 0 0 = BOOTP initially
1 = BOOTP/DHCP disabled
2 = BOOTP fallback
(6)
3 = BOOTP always
(6)
4 = DHCP always
(6)
(6) Series C and higher.
Baud Rate
(3)
(3) Changes to the Baud Rate take effect when the ENI/ENIW power is cycled, or the configuration is saved to
flash.
See page 4-14. Autobaud enabled with
autodetect of CRC/BCC
Ethernet Hardware
Address Factory Value - Read Only
(see the nameplate on the
unit) Factory Value