Rockwell Automation 1761-NET-ENIW MicroLogix Ethernet Interface (ENI) User Manual - Manual (Page 46)

Publication 1761-UM006E-EN-P - August 2005
4-6 ENI/ENIW Configuration (Nodes 241 to 254)
Reset
Use the Reset screen to issue reset commands and to set the type of
behavior that will occur at reset. The reset behavior options are
described on page 4-19.
For configurations uploaded from an ENI, the reset screen also
displays information, such as the ENI/ENIW Ethernet hardware
address and ENI/ENIW firmware revision.
Use the Configuration Utility Over RS-232
TIP
When using the ENI/ENIW Configuration Utility, be
sure to use a 1761-CBL-PM02 series C cable
between the ENI/ENIW and the computer.
Also, make sure RSLinx is not running a driver that
is using the COM port that you plan to use for the
ENI/ENIW Configuration Utility.