Rockwell Automation 1756-XXXX ControlLogix Digital I/O Modules - Manual (Page 109)

Rockwell Automation Publication 1756-UM058G-EN-P - November 2012 109
Chapter
6
Install ControlLogix I/O Modules
Topic Page
Install the Module 111
Key the Removable Terminal Block 113
Connect the Wires 114
Assemble the Removable Terminal Block and Housing 119
Choose Extended-depth Housing 120
Install the Removable Terminal Block 122
Remove the Removable Terminal Block 123
Remove the Module from the Chassis 125
ATTENTION: Environment and Enclosure
This equipment is intended for use in a Pollution Degree 2 industrial environment, in overvoltage Category II applications (as
defined in IEC 60664-1), at altitudes up to 2000 m (6562 ft) without derating.
This equipment is not intended for use in residential environments and may not provide adequate protection to radio
communication services in such environments.
This equipment is supplied as open-type equipment. It must be mounted within an enclosure that is suitably designed for those
specific environmental conditions that will be present and appropriately designed to prevent personal injury resulting from
accessibility to live parts. The enclosure must have suitable flame-retardant properties to prevent or minimize the spread of
flame, complying with a flame spread rating of 5VA or be approved for the application if nonmetallic. The interior of the
enclosure must be accessible only by the use of a tool. Subsequent sections of this publication may contain additional
information regarding specific enclosure type ratings that are required to comply with certain product safety certifications.
In addition to this publication, see the following:
• Industrial Automation Wiring and Grounding Guidelines, publication 1770-4.1 , for additional installation requirements.
• NEMA Standard 250 and IEC 60529, as applicable, for explanations of the degrees of protection provided by enclosures.