Rockwell Automation 1757-FFLDC4 FOUNDATION Fieldbus System User Manual - Manual (Page 88)

88 Rockwell Automation Publication 1757-UM012A-EN-P - July 2011
Chapter 5 Create an RSLogix 5000 Software Project
2. On the Module Properties dialog box, click the Connection tab.
In this tab, you can inhibit the module and enable a major fault on the
controller if the connection fails in Run mode.
See page 92 for more information.
3. On the Module Properties dialog box, click the Fieldbus tab.
4. Click the icon to launch RSFieldbus software.
You can create a linking device in RSLogix 5000 software or RSFieldbus
software. But, you must associate the linking device with field devices on
the H1 segment in the RSFieldbus software.
See page 33 to program your linking device with field devices.