Rockwell Automation 2706-P42_P43_P44_P72_P74_P92_P94 InView Marquee Message Display User Manual - Manual (Page 11)

Publication 2706-UM016D-EN-P - March 2006
Install InView Marquee Message Display 1-3
2. Remove the left or right conduit hole plug from the top of the
enclosure by removing its wing nut inside the enclosure.
Save the hole plug for a later step.
3. Insert the power wires through the left conduit hole on either
the top or the bottom of the sign.
4. Strip the wires back 6.35 mm (1/4 in.). Connect the incoming
electrical wires.
Hole plugs,
top, removed
Wing nuts for
hole plugs Hole plugs,
bottom, removed
TIP
It is recommended that you install power and
serial wires at the bottom of the power supply
enclosure to reduce noise from power wires
crossing serial wires.
You can install the power or serial wires at the
top of the enclosure if necessary.
TIP
Use watertight conduit connectors only.
Flexible conduit should be used.
TIP
Be sure to place the wires so they are not caught by
screws when replacing the power supply cover, and
also so they do not interfere with fan operation.
Insert the
power wires
into one of
these
conduits.
Internal
serial wires
Internal wiring for
power supply