Rockwell Automation 2706-P42_P43_P44_P72_P74_P92_P94 InView Marquee Message Display User Manual - Manual (Page 48)

Publication 2706-UM016D-EN-P - March 2006
2-10 InView System Connectivity
Power-up Messages After the power cable and the download cable (attaches to the RJ-12
port) have been attached per the installation document, apply power
to the display.
2706-P42, 2706-P43, 2706-P44, 2706-P72, 2706-P74, 2706-P92, and
2706-P94 Displays
After power is applied to the display the following messages are
displayed.
• firmware number and revision
• memory size and partition
• memory checksum message
• date and time
• address of the display; and background message, if one was
created
2706-P22: Display
After power is applied to the display the catalog number, firmware
revision, and address is displayed on one screen. Then the
background message is displayed.
See the help file for more details on the following topics.
TIP
If a display is connected to Ethernet via TCP/IP by
using a 2706-PENET1 module or a 2706-P9x display
is connected to Ethernet via TCP/IP, the display
configuration and message download can be done
over Ethernet. For more information on this
communication option, see publication 2706-IN008.