Rockwell Automation 2706-P42_P43_P44_P72_P74_P92_P94 InView Marquee Message Display User Manual - Manual (Page 18)

Publication 2706-UM016D-EN-P - March 2006
1-10 Install InView Marquee Message Display
Stack Mount
To stack the signs:
1. Remove the top screw from each end cap of the bottom sign
2. Use the screw removed in Step 1 to fasten a stacking bracket to
each end cap, countersunk side out, and torque to 2.7 Nm
(24 lb-in).
3. Remove the top and bottom screws from each end of the
remaining signs.
4. For each end of the signs, secure the stacking bracket from the
bottom sign to the next sign using one of the screws removed in
Step 3 and torque to 2.7 Nm (24 lb-in).
5. Secure a ceiling bracket to the top of each end cap on the top
sign.
See Step 2 of the Ceiling Mount instructions on page 1-9.
6. Use a chain (not supplied) to hang the signs from the ceiling.
TIP
Up to 4 signs can be hung together vertically
(‘stacked’). Mounting system for stack mounting must
support a minimum of four times the total weight of
all signs being stacked.
WARNING
Possible crush hazard. Do not stack more than 4
signs. Otherwise signs may fall causing serious injury
or death.
Stacking
bracket
Screw
Remove
these
screws.
Stacking bracket
Bottom sign
Next sign
Ceiling
bracket
Top sign
Stacking
bracket