Rockwell Automation 2706-P42_P43_P44_P72_P74_P92_P94 InView Marquee Message Display User Manual - Manual (Page 14)

Publication 2706-UM016D-EN-P - March 2006
1-6 Install InView Marquee Message Display
If needed, there is an extra hole plug supplied in addition to any
hole plugs removed in Step 2 on page 3.
9. Replace the power supply cover using the 6 screws from when
the cover was removed.
10. Torque the screws to 2.7 Nm (24 lb-in).
11. Connect the power cable to a power source.
Mount the 2706-P42,
2706-P43 and 2706-P44
Displays
Disconnect power before you mount a sign.
TIP
Only qualified personnel should install the InView
signs.
InView signs are for indoor use only and should not
be continuously exposed to direct sunlight.
Mounting hardware that is used to hang or suspend
signs must be capable of supporting at least 4 times
the total weight of any/all signs mounted together.
For integrity of the case, do not drill holes in or
modify the case.
WARNING
Hazardous voltage. Contact with high voltage may
cause death or serious injury. Always disconnect
power to sign prior to servicing.