Rockwell Automation 2706-P42_P43_P44_P72_P74_P92_P94 InView Marquee Message Display User Manual - Manual (Page 15)

Publication 2706-UM016D-EN-P - March 2006
Install InView Marquee Message Display 1-7
Wall Mount
To mount the display to a wall:
1. Remove the 4 screws and the end cap from one end of the sign.
2. Slide one of the wall mounting brackets onto the back of the
sign until it is approximately 13 mm (0.5 in.) away from the end
of the sign.
3. Use two 10-32 x 1/4 Phillips screws (supplied) to secure the wall
mounting bracket to the back of the sign.
4. Torque the screws to 2.7 Nm (24 lb-in).
5. Replace the end cap using the 4 screws removed in Step 1
above.
6. Torque the screws to 2.7 Nm (24 lb-in).
7. Repeat Steps 1 to 6 for the other end of the sign.
Approximate distances between the bracket holes,
center-to-center, are shown below.
TIP
Remove only one end cap at a time.
Remove
these
screws.
33.13 (1.305)
127 (5.00)
2.65 (0.105)
33.13 (1.30)
25.40 (1.00)
12.70 (0.50)
7.62 (0.30)
17.65 (0.70)
75.95 (2.99)
40.64 (1.60)
30.35 (1.195)
30.35 (1.195)
4.04 (0.159) 10- 32 UNC-2B 2 Holes
7.11 (0.280) Thru 3 Holes
Wall mounting
bracket
0.5”
Wall
mounting
bracket
Dimensions are in mm (inches).
Phillips
screws go
here.
Fasten
these
screws.