Rockwell Automation 2706-F11J_F11JC_F21J_F21JC DL50 INSTALLATION MANUAL - Manual (Page 134)

VOLTAGE: 95-120 / 190-240V AC
FREQUENCY: 50-60 Hz
L1 (HOT)
L2 (NEUTRAL)
E. GND
FUSE INFORMATION European: 2.5 A TYPE GMA
U.S.A.: 2.5 A TYPE AGC
TB1
AC INPUT
INSTALLATION / DIAGNOSTICS INFORMATION
RELAY
WARNING: HIGH VOLTAGE
USE CAUTION
WARNING: WHEN POWER IS REMOVED, THE
ANUNCIATOR WILL BE ENERGIZED IF NORMALLY
CLOSED OUTPUT IS USED.
RATING: 3A @ 240 VAC RESISTIVE LOAD
3A @ 30 VDC RESISTIVE LOAD
TB2
NORMALLY OPEN
NORMALLY CLOSED
COMMON
RS-485 PORT
TB3
TB4
EARTH GROUND
RS-232 PORT
SHIELD
COMMON
+
–
TERMINATION
TRANSMIT
RECEIVE
GROUND
CONFIGURATION DIPSWITCH DEFINITIONS
S1 S2 S3
NOTE: EARTH GROUND SHOULD BE CONNECTED TO CHASSIS
FIRST BEFORE GOING TO TB1.
CONTROLLER BOARD CONFIGURATION DIP SWITCHES
WARNING: TO AVOID RISK OF SHOCK, DISCONNECT TB1 AND
TB2 BEFORE ATTEMPTING TO SERVICE THE DISPLAY.
WARNING: USE RELAY FOR ANUNCIATOR ONLY.