Rockwell Automation 2706-F11J_F11JC_F21J_F21JC DL50 INSTALLATION MANUAL - Manual (Page 24)

Chapter 3
Configuring the DL50
3–7
The DL50 loads DIP switch settings on power-up and when the RESET
button is pressed. The RESET switch is located on the left side of the
processor board (refer to Figure 3.3).
Figure 3.3
Reset Switch
Reset
Switch
RESET
RESET
Press this momentary switch to begin the reset. The DL50 will enter the
self-test mode and display power-up status information as shown in
Figure 3.4.
DL50 Reset