Rockwell Automation 2706-F11J_F11JC_F21J_F21JC DL50 INSTALLATION MANUAL - Manual (Page 81)

Chapter 6
Slave Mode Operation / Examples
6–17
This is what the data files look like:
N7:100 \00\26 \05\01 _R B_ Mo du le _t o_ DL
Address 0 1 2 3 4 5 6 7 8 9
N7:110 50 _ _ \05\01
Note: _ = Space
DL50 Address Byte = 5
DL50 Line No. = 1
Source (5) = Backplane Destination (01) = Port 1
Byte Count
(Including Words
N7:100
! N7:112) = 26
Note: If byte swapping is enabled, all data should end on a word boundary
(must have even number byte count)