Rockwell Automation 8720MC High Performance Drives Installation Manual - Manual (Page 69)

Publication 8720MC-IN001D-EN-P — December 2002
Connecting Your 8720MC 3-7
Using Lug Connectors The D frame has stud type terminals, which require using lug
connectors for cable terminations. The following table shows the lug
selection for each possible cable choice. Choose connectors for each
installation based on the desired cable sizes, the application
requirements, and all applicable national, state, and local codes.
Lug Selection
1
5/16 inch stud. All other studs are 3/8 inch.
Drive Catalog
Number
Output U, V, W and PE
DC+
DC-
TE
Cable (per Phase)
mm
2
(AWG)
T & B Part No.
(8 required) Cable (per Phase)
mm
2
(AWG)
T & B Part No.
(2 required) Cable (per Phase)
mm
2
(AWG)
T & B Part No.
Number
8720MC-D097 33.6 (2) 54147
1 21.2 (4) 54139
1 13.3 (6) 54135
1
8720MC-D120 53.5 (1/0) 54153
1 33.6 (3), (2) 54142
1 13.3 (6) 54135
1
8720MC-D149 85.0 (3/0) 54163
1 53.5 (1/0) 54153
1 13.3 (6) 54135
1
8720MC-D180 107.2 (4/0) 54168
1 67.4 (2/0) 54110
1 21.2 (4) 54139
1