Rockwell Automation 2080 Micro800 Digital and Analog Plug-in Modules - Manual (Page 89)

Rockwell Automation Publication 2080-UM004B-EN-E - December 2013 81
Quickstart Appendix B
2. Next, wire your 2080-DNET20 plug-in following the diagram
shown below.
3. Configure the DeviceNet devices as shown below.
4. Set the node address for the CompactBlock LDX through the node
switches to node 1.
5. Set the node address for the PowerFlex drive through the 25-COMM-D to
node 2. Set the baud rate to autobaud.
Color Chips (dots)
Red Dot
Black Dot
Blue Dot
White Dot
10-position Plug 5-position Plug
D
D
D
D
D
Linear Plug
10-position
Drop Line or
DeviceNet
Trunk Cable
Red
White
Bare
Blue
Black
DeviceNet
Port Pinout
V+ (RED)
CANH (WHITE)
SHIELD
CANL (BLUE)
V- (BLACK)
20474
Esc Sel
Micro800 controller
CompactBlock LDX
COMM
power
supply
Component on
DeviceNet
Network
PowerFlex 523
with
25-COMM-D
COMM
power
supply
1 KwikLink Lite IP20 Flat Media
2 Trunk Line Connector
3 Drop Line Connector
4 Terminating Resistor
5 5-pin Open Style Connector
6 Power Tap with terminating resistor
46220