Configuration, Import the following dnet udfbs into your project, Configure the ra_dnet_master udfb as shown – Rockwell Automation 2080 Micro800 Digital and Analog Plug-in Modules User Manual
Page 90
Advertising
82
Rockwell Automation Publication 2080-UM004B-EN-E - December 2013
Appendix B Quickstart
Configuration
1.
Launch Connected Components Workbench and open the sample project
you have downloaded from the Sample Code Library.
2.
Import the following DNET UDFBs into your project:
• RA_DNET_MASTER
• RA_DNET_LDX_DISCRETE
• RA_PF_DNET_STANDARD
See
User Defined Function Blocks on page 45
for information on input
and output parameters for these UDFBs.
3.
Configure the RA_DNET_MASTER UDFB as shown.
4.
Configure the PowerFlex UDFB as shown (that is, set the node address,
plug-in slot ID, and so on).
Advertising