Build and download, Execute program, Set micro800 controller to run mode – Rockwell Automation 2080 Micro800 Digital and Analog Plug-in Modules User Manual
Page 91: Set the scanner to run mode, Build and download execute program
Advertising
Rockwell Automation Publication 2080-UM004B-EN-E - December 2013
83
Quickstart Appendix B
5.
Configure the CompactBlock LDX UDFB as shown (that is, set the node
address, plug-in slot ID, Module1…Module4).
Build and Download
Build and download the project into the controller.
Execute Program
1.
Set Micro800 controller to RUN mode.
2.
Enable AutoScan in the DeviceNet Scanner UDFB.
This will scan all the active nodes and populate the scan list.
3.
Set the Scanner to RUN mode.
Advertising