Rockwell Automation 9330-CC ControlGuardian User's Guide - Manual (Page 122)

Configuring Security
9-3
Setting Up System Security
To set up system security, do the following:
Note When you enter security system setup for the first time, the system prompts you to
enter a master access password. Type any password you want to use. The next time
you access system security, you have to enter the password you specified.
Use function keys to
configure security items.
See Table 9.A.
Use the keys to move
through the system setup menu.
F4
Enter Master
Access Password
F1
System Setup
or
Configure Program
F8
Configure
Security
Main Menu
Parameters
6 2 0
Table 9.A
System Setup Field Descriptions
If you want to: Press this key:
Toggle security system on or off.
F1
Enable/Disable Security System
Enable or disable user disk log. The user disk log keeps a record of each user
who logs in, which function was used and the duration of access to the system.
F2
Enable/Disable User Disk
Logging
Print the user log if it has been enabled. You can print to a printer or a disk file
by entering the device or a DOS path and filename.
F3
Print User Log
Remove the current user log stored on disk.
F4
Clear User Log
Specify a path to store user activity log file.
Note
: Under normal operation this field should be left at the default.
F5
Specify User Log Path
Redefine the password needed to access the security system setup.
F6
Define a New Master Password
Define the paths for backups of master files. See chapter 6.
F7
Configure Device Paths