Rockwell Automation 9330-CC ControlGuardian User's Guide - Manual (Page 26)

Preface ControlGuardian User’s Guide
2-6
Table 2.D lists the system requirements for running Windows.
Table 2.D
Requirements for Running ControlGuardian in Windows
Requirements: Notes:
minimum 80486, 33 MHz computer recommended minimum hardware for acceptable performance
communication interface 1784-KL 1784-T47
1784-KT IBM 80486 or compatible
1784-KT2 IBM PS/2
1784-KTX, KTXD any computer with a 16-bit ISA or EISA
expansion slot
1784-PCMK notebook computer
RS-232 port any IBM compatible computer
Microsoft Windows 3.1 must be running in 386 Enhanced Mode
MS-DOS MS-DOS 3.1 or later
547 Kbytes or more base RAM available
after running Windows
Recommendations for CONFIG.SYS
To run multiple sessions of ControlGuardian software, set:
· FILES=50
· BUFFERS=30
If you use a memory manager, make sure the device statement the memory address
of the communication card. To do this:
· add EMMExclude=xxxx-yyyy to the [386Enh] section of the Windows
SYSTEM.INI file