Rockwell Automation 9330-CC ControlGuardian User's Guide - Manual (Page 46)

Configuring Communications
3-15
Configuring a LAN Logistics Server (NetBios)
For information on the configuration characteristics for a LAN Logistics Server
(NetBios), see Table 3.K.
Table 3.K
Configuration Characteristics for the LAN Logistics Server (NetBios)
If you want to: Press this key:
Assign a unique communication device name (1-8 characters). This
field must be defined for the software to accept the configuration.
You cannot modify this field after you save the configuration. The
communication device name that you assign appears at the top of
the screen when you use WHO.
F1
Device Name
Assign a description for a communication device (1-50 characters).
You must define this field for the software to accept
the configuration.
F2
Enter Device Description
Select the LAN Logistics Server (NetBios) option.
F3
Select Interface Hardware
Assign a timeout for processor reply. Available choices are: 15, 20,
25, 30, 35, 40, 45, 50, 55 and 60 seconds. The default is
20 seconds.
F4
Online Wait for Reply
Enter default Novell Netware Server name (1- 9 characters).
F5
Default Server Name
Enter a programming terminal name (1- 8 characters).
F6
Terminal Name
Define the following:
·Network mode (choose between: local, remote, and DH+ routing)
·Local node address (octal)
·Remote address (octal)
·Destination link ID (decimal) for DH+ routing
·Bridge address (octal) for DH+ routing
The default is local.
F9
Network Mode