Rockwell Automation 9330-CC ControlGuardian User's Guide - Manual (Page 142)

Preface ControlGuardian User’s Guide
10-8
Table 10.C
Ladder Parms 1 Function Key Descriptions
If you want to: Press this key:
Determine which printer codes will be sent at the start of each line on the
ladder report. Toggle through Normal, Compressed, Enhanced,
Normal/Compressed, Raw Normal, and Raw Compressed. The default
is normal.
F2
Ladder Print Mode
Choose the placement of the rung descriptions. Toggle between Fit in
Rung or No Compress. Fit in Rung causes the rung description to remain
within the power rails. No Compress prints the rung descriptions the
width of the page regardless of the power rail boundaries.
F3
Rung Desc. Print Mode
Place a framing character around all rung descriptions printed.
F4
Box Rung Description
Keep all components of an instruction on the same page. Toggle
between yes and no. The default is no.
F6
Chk Page on Vertical Split
Select the mode to print timer and counter instructions. Toggle between
Normal Block Mode and Small Mode. The default is normal mode.
F6
Instruction Print Mode
Choose the number of lines of text to be printed above instructions on the
ladder diagram. Toggle through 0, 1, 2, 3, 4 and 5. The default is 0.
F7
# of Des Lines to Print
Toggle through Normal, Replace, or None. Normal prints both address
and symbol. Replace omits the address when the symbol name is
present. None prints address only.
F8
Symbolic Mode
Display the card type below instructions that reference defined modules.
Toggle between yes and no. The default is yes.
F9
Show I/O Cards
appears on the screen, but is not supported
F1
Although the F1 key appears on this configuration screen, it has no affect on the
actual ladder report. Ignore this function key.