Rockwell Automation 9330-CC ControlGuardian User's Guide - Manual (Page 143)

Generating and Printing Reports
10-9
Use Table 10.D to help choose which ladder print mode you want to use:
Table 10.D
Choosing which Ladder Print Mode to Use
If you want to: Choose this mode:
Print the ladder report using ControlGuardian’s standard font.
Longer rungs may wrap on multiple lines of the report.
normal
Print the ladder report using a smaller font so longer rungs don’t
wrap on multiple lines.
compressed
Alternate between normal and compressed font sizes as needed,
depending on the width of each rung and its text description.
enhanced
Alternate between normal and compressed modes as needed,
depending on the width of each rung and its text description.
normal/compressed
Print the ladder report in compressed mode, but without any page
breaks. This option provides a continuous report listing.
raw compressed
Print the ladder report in normal mode, but without any page
breaks. This option provides a continuous report listing.
raw normal
Table 10.E
Ladder Parms 2 Function Key Descriptions
If you want to: Press this key:
Enable output cross-reference on the ladder printout and determine their
placement. Toggle through none, below, side, and side/below. The default
is none.
The side/below option prints as many cross-references as possible to the right
of the rung and then continues with additional cross-references below.
F1
Output Xref
Print a rung number reference below input instructions indicating the next
occurrence of that address as an output. Toggle between yes and no. The
default is yes.
F2
Input Xref
Determine cross-reference print mode. Toggle between Normal and
Compressed. Normal mode includes the specific instruction types for each
reference. Compressed mode is abbreviated. The default is normal.
F3
Ladder Xref Print Mode
Choose to ignore or acknowledge a disable flag in the data base. Toggle
between yes and no. If yes, this option ignores the disable flag without
changing the data base. The default is no.
F4
Ignore Xref Disable Flg
Choose to have the address always appear along with the
cross-reference data. Toggle between yes and no. The default is no.
F5
Force Addr on Side Xref
Specify the maximum number of horizontal characters to allow for
cross-reference data to the right of the rung diagram. The default is 32.
F6
Side Xref Column Width
Enable or disable the printing of the right power rail. You can disable the
printing of the right power rail as long as the side cross-reference print
is disabled. Toggle between yes and no. The default is yes.
F7
Print Right Power Rail
Note: Cross-reference parameters are only available with A.I. series programs.
Application tip