Rockwell Automation 9330-CC ControlGuardian User's Guide - Manual (Page 21)

a: is the drive where you insert the disk.
c: is any destination hard-disk for the
ControlGuardian software.
Installing and Starting the Software
2-1
2
Installing and Starting the Software
Chapter Objectives
Use the information in this chapter to install the software and configure the software
for use in DOS and Windows
â . For information on system specifications, see
appendix A.
Where to Start
To use ControlGuardian software you need a working knowledge of:
· Allen-Bradley PLC-2, PLC-3, PLC-5, or SLC 500 processors
· PanelView 1200 pass through
· your programming terminal
· your programming software
· A.I. series software
· 6200 software
Installing the Software
At the DOS prompt, insert the disk labeled “Disk 1 of n” into the disk drive, where n
is equal to the total number of disks. Type:
A: Enter
INSTALL C: Enter