Rockwell Automation SP120 ACDrive 115VAC, 1Ph, 230VAC, 1Ph/3Ph, 1/4-5.0HP - Manual (Page 12)

1-2 SP120 AC Drive Installation and Operation
English
1.3 Receiving Your New Drive
It is your responsibility to thoroughly inspect the equipment before accepting shipment
from the freight company. Check the item(s) received against your purchase order. If
any items are obviously damaged, do not accept delivery until the freight agent notes
the damage on the freight bill.
1.3.1 Unpacking the Drive
Remove all packing material, wedges, or braces from within and around the drive.
Remove all packing material from the heat sink. Leave the debris cover in place on
the top of the drive.
If you find any concealed damage during unpacking, notify the freight agent. Also,
leave the shipping container intact and have the freight agent make a visual inspection
of the equipment to verify damage.
1.3.2 Inspecting the Drive
After unpacking, check the item(s) nameplate catalog number against your purchase
order. An explanation of the model numbering system for the SP120 drive is provided
in Figure 1.1 as an aid for nameplate interpretation.
Important: Before you install and start up your SP120 drive, inspect for mechanical
integrity. Look closely for loose parts, wires and connections.
1.3.3 Storage and Operating Conditions
Follow these recommendations to prolong drive life and performance:
• Store within an ambient temperature range of –25 o C to 70 o C.
• Store within a relative humidity range of 20 to 90%, non-condensing.
• Avoid storing or operating the drive where it could be exposed to a corrosive
atmosphere.
• Protect from moisture and direct sunlight.
• Operate within an ambient temperature range of –10 o C to 40 o C.
Important: To operate the drive between 40 o C and 50 o C, make the following
adjustments:
• Reduce the carrier frequency to 2 kHz
• Reduce the output current to 80% of the drives rated current
• Remove the debris cover from the top of the drive