Rockwell Automation SP120 ACDrive 115VAC, 1Ph, 230VAC, 1Ph/3Ph, 1/4-5.0HP - Manual (Page 35)

Parameters and Programming 3-5
English
Restoring Factory Defaults
This example shows you how to reset the factory defaults of the drive.
Action Description Display
Press Down Arrow to advance to the b parameter
group. b--
Press PROGram to enter into the b parameter
group. b01
Press Up Arrow to scroll through the parameters
until b84 [
RESET FUNCTIONS ] is displayed.
b84
Press PROGram to view the parameter value stored
in b84 - [
RESET FUNCTIONS ] and verify that it is set to
01. If it is not 01, use Up Arrow to change the value
to 01, then press Enter.
Note: The defaults will be reset to the values
determined by b85 [
FACTORY DEFAULT SELEC t].
01
Press PROGram to return to the parameter number
without changing the stored value. b84
Press and hold PROGram, Up Arrow, Down Arrow,
and Stop for 3 seconds. b84
Release the Stop Key and continue to hold the
PROGram, Up Arrow, and Down Arrow until the
display begins to blink. Release the remaining keys.
When this is done, 0.0 will be displayed (this is d01
[
OUTPUT FREQUENCY ].
0.0
PROG
PROG
PROG
PROG
PROG