Rockwell Automation SP120 ACDrive 115VAC, 1Ph, 230VAC, 1Ph/3Ph, 1/4-5.0HP - Manual (Page 31)

Parameters and Programming 3-1
English
C
HAPTER
3
Parameters and Programming
This chapter describes how to program the drive and provides a parameter reference
that describes all of the drive parameters.
3.1 Programming the Drive Using the Keypad
The keypad is located on the front panel of the drive. This is an integrated keypad that
can be used to monitor drive operation, program parameters, and operate the drive.
The PROGram, Up Arrow, Down Arrow, and Enter keys are located inside the front
panel cover. You must open the cover to access these keys. The drive uses a
4-character, 7-segment LED display to show parameter numbers, parameter values,
and diagnostic codes. Refer to section 4.4 for a description of the diagnostic codes.
!
ATTENTION: Wait at least 6 seconds after programming the SP120 drive
before issuing a start, reset command, or switching off the power supply.
Failure to wait 6 seconds could result in failure to recognize programming
changes, which could result in bodily injury or damage to equipment.
ATTENTION: If the Stop key is used to clear a fault and there is a valid
run command, the drive will start to run as soon as the fault is cleared
without cycling the run input. Failure to observe this precaution could
result in severe bodily injury or loss o f life.
Table 3.1 – Keypad Functions
Key Description
PROGram is a dual purpose key. It is used to view parameter
groups and to switch between parameter numbers and values.
PROGram also acts as an escape key to exit the parameter
values without changing them.
Up Arrow and Down Arrow are used to scroll through
parameters, or to increase and decrease parameter values.
Enter is used to enter the current value into memory.
Start can be activated using A02 [ START COMMAND SELECT ] or
digital input setting 31{OPE}. When active, the key will start
the motor in the direction of rotation defined in F04 [
START KEY
DIRECTION ].
The Speed Potentiometer can be used to set the
commanded speed. The speed potentiometer can be
activated using A01 [
FREQUENCY COMMAND SELECT ].
Stop is used to stop the motor. If the drive has stopped due to
a fault, pressing this key will clear the fault.
PROG
Min Max