Rockwell Automation SP120 ACDrive 115VAC, 1Ph, 230VAC, 1Ph/3Ph, 1/4-5.0HP - Manual (Page 32)

3-2 SP120 AC Drive Installation and Operation
English
Table 3.2 – LED Functions
LED Will be on when:
POWER power is applied to the drive (mains supply is switched on).
Important: The DC-bus capacitors and terminals are
energized even when the mains supply is
switched off.
RUN the drive is in operation. For example, if a start command
has been given.
PRG the drive is being programmed.
Hz
output speed is being displayed.
A
output current is being displayed.
Start Key the Start key has been pressed.
Speed Pot the speed pot is active.
Figure 3.1 – Programming Overview
Parameter
Entry
Saving entered
Parameters
d01
d01 d01 d01 d01
F04
C ..
A ..
F01
b ..
d09
A01
A98
b01
b89
C01
C91
PROG
PROG
PROG
PROG