Add distributed i/o modules to the project, Before you begin, What you need – Rockwell Automation 1769-L3xx CompactLogix System Quick Start User Manual
Page 113: Chapter 11, Add distributed i/o, Modules to the project, Before you begin what you need
113
Publication IASIMP-QS001C-EN-P - October 2009
113
Chapter
11
Add Distributed I/O Modules to the Project
In this chapter, you add distributed POINT I/O modules to your project using RSLogix 5000
programming software. You also add ladder logic and download the project to the controller
so you can test communication with an I/O module. This project builds upon the program
created in
Before You Begin
•
Prepare the POINT I/O hardware, see
•
Create a project in RSLogix 5000 programming software, see
What You Need
•
A POINT I/O module with digital outputs, this example uses a 1734-OB4E
•
This example includes the following modules as well, but they are not required:
1734-IB4, 1734-OE2C
•
For an EtherNet/IP network, no additional software is required
•
For a ControlNet network, RSNetWorx for ControlNet software
•
For a DeviceNet network, RSNetWorx for DeviceNet software