Rockwell Automation 1769-L3xx CompactLogix System Quick Start - Manual (Page 68)

68 Publication IASIMP-QS001C-EN-P - October 2009
Chapter 5 Prepare the PowerFlex 40 Drive
0.5-0.6 N-m
(4-5 lb.-in.)
4. Place the adapter cover on the PowerFlex.
5. Tighten the screws.
6. For all networks, connect the network cable to the
adapter.
7. Apply power to the PowerFlex 40 drive.
Important: The front side of the ControlNet adapter faces down
when it is installed in the drive. So, in the installed position, port
A is to the right of port B.
3. Snap the adapter into the cover and connect the cable from the adapter to the
PowerFlex 40 drive.
0.5…0.6 Nm
(4…5 lb-in)