Prepare the panelview plus terminal, Before you begin, What you need – Rockwell Automation 1769-L3xx CompactLogix System Quick Start User Manual
Page 71: Chapter 6, Prepare the panelview plus, Terminal, Before you begin what you need
71
Publication IASIMP-QS001C-EN-P - October 2009
71
Chapter
6
Prepare the PanelView Plus Terminal
In this chapter, you mount and wire power to a PanelView Plus terminal. You also configure
network communication and make network connections.
Before You Begin
Determine which network connection to use: EtherNet/IP, ControlNet, or serial.
Regardless of which CompactLogix controller you use, you need to connect to the PanelView
Plus terminal via an EtherNet/IP network for initial configuration, via a cross-over cable or
an Ethernet switch.
What You Need
•
PanelView Plus terminal
•
For a ControlNet network (option 2), use a PanelView Plus ControlNet interface
module
•
One power supply, either a 1794-PS3 or a 2711P-RSACDIN
•
Ethernet cable and switch or Ethernet cross-over cable
•
For a serial connection (option 3), 2706-NC13 cable