Rockwell Automation 1769-L3xx CompactLogix System Quick Start - Manual (Page 51)

Publication IASIMP-QS001C-EN-P - October 2009 51
Prepare the Distributed POINT I/O Hardware Chapter 3
Mount the POINT I/O Modules
All controllers, POINT I/O modules, and wiring bases
1. Using a small, flathead screwdriver, rotate the
keyswitch to match the figure on the I/O
module.
2. Press the module into the wiring base.
3. Snap the handle up.
4. Complete steps 1 – 3 with all POINT I/O
modules.
5. Slide the first module and wiring base
assembly along the adapter and press it
onto the DIN rail.
6. Repeat with all of the I/O assemblies.
Handle
Tongue-and-groove Slots
ATTENTION
The 1734-IT2I module must be mounted in the 1734-TBCJC wiring base. All other modules can be
mounted in either of the 1734-TB or 1734-TBS wiring bases.
Figure on Module
Wiring Base
Module